Support > Repository > Layout > Repetitive Container - Tab and Multistage Layout
ja | en

You can use a repeating container multistage layout with tabs.

Figures 1 and 2 show examples in which multiple iteration containers to which multistage layout is applied are tabbed.

Figure 1 "Fax Recording" Container
Fig. 2 "Telephoto record" container

Item definition

Fig. 3 shows the model items that make up multiple repeating containers such as "FAX record" and "Telapo record".

Figure 3 Defining multiple repeating containers

Layout name

Here we put all repeating containers in one tab.The tab name is "* T".
All items in the repeating container are started with the layout name "* T>".

In addition, we have set up multistage layout with each repeating container."* C1, * C2", "* D1, * D2", "* E1, * E2" for each repeating container.(Figure 4)

Figure 4 Setting the layout name

Group tab

Set the layout name "* T" prepared in Figure 4 as "Tab".(FIG. 5)

Figure 5 Tab Settings

Repeat container layout - label name

Set label names "a", "b" and "c" for each container.

Figure 6 Label name setting

Figure 7 shows the alignment image of label name "a".The position of "Status (FAX)" item and "Memo" item is matched.

Figure 7 Label name alignment image

Repeat container layout - merge items

The item "memo" shall take the same area as the three items "Status (FAX)", "Implementation Date" and "Person in charge (FAX)" above.It is described as "3" as shown in Fig.(When covering four items, write "4".))
With this designation, horizontal columns can be combined into one.

Figure 8 Join configuration
Figure 9 Horizontal join image